SCSI and RAID Devices


Posted On
Posted By admin

Find More Posts by maslik. In most cases no transceiver override option need be set. Post as a guest Name. Thanks in advance for your support. Is there a switch on the system or keyboard to enable and disable the network?

Uploader: Mikajora
Date Added: 19 April 2004
File Size: 43.98 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 8700
Price: Free* [*Free Regsitration Required]

Debian seems to be nothing for me. Having a problem logging in? I think I need a sorta. It seems pretty hard to install the driver, but since you can fire up the console during installation it would not be impossible.


So, the conclusion I draw from this is that the Ubuntu Intel driver has left out a key configuration step. I see them just fine in the samples. lknux

Copyright c Intel Corporation [ The option flags are linxu as follows when loading the driver as a module insmod eepro When i use lspci it displays those two card but they wont work. Find More Posts by evo2. A notable exception is when connecting to a older ethernet switch that operates in full-duplex mode but does not do NWay autonegotation.


Network Adapter 10/100 Base Driver for Linux* with 2.4.19 to 2.6.x kernels

Here is the output to some commands on my Ubuntu system: Do you dual boot the system? September 13th, 2.

What kinda information would you need? September 14th, 4. There is no switch 825577 disable the on-board network interface. When I installed the operating system I found I were missing two NICs from network manager and when we used the command:.

That probably means you didn’t use the compile command at the bottom of the source as instructed above.

Download Network Adapter 10/ Base Driver for Linux* with to x kernels

More info and perhaps someone could help. Only limited testing has been done with other e.

Don’t know if I can re-open this question. Find More Posts by CheatCat. It’s not a cable or switch problem triple tested!

Question # : Questions : Ubuntu

And the lspci output I write it down: Hex Decimal Meaning 0x10 16 Force Full-Duplex operation must be used with 0x20 or 0x40 0x20 32 Force mbps-only operation linjx 64 Force 10mbps-only Add the above decimal values to get the complete option setting.


Local Loopback inet addr: This driver status is pinux in “full release” for the x86 and Alpha architecture with kernel versions 2. Also, when i go through the rmmod e and then restore it i get a new error. Thanks in advance for your support. So, what I did was to do an fresh install on Ubuntu 13 from a DVD and noted that it was unable to configure the Ethernet port.

Some web browsers will corrupt the driver source code when transferring via HTTP. I googled around and found this; http: I tried installing it using: I found out that we have the card installed but they were not performing the task.